The speeds allowed for the V4 circuits depend on the hardware reference (with/without double fi eld and plus FC) and the washing machine capacity (in kg and are as follows: motor 1250 double field motor 6 kg kg FC (motor converter) 6 kg kg 20 technical.
3 Configure manual Recirculation 4 Configure Cold water aquatronic 5 Configurar Door opening Press plus the start button for 3 seconds and the screen displays: Select F7-212 AA 8kg ABS Turbo Time Plus aquatronic 1200.p.m.
2 is a short (quick) compact programme which takes 30 minutes and heats to 30C.Used in machines with variable spin; makes rotating movements when manual washing and spinning.To select the time delay in hours, press the clock button.Recirculation pump Doubly connected electrically operated valve Re-circulates the drum water for greater wash effectiveness and reduced programme times. 1 technical support service technical study technical product: Washing machines 7 / 8 /.
(Revolutions per minute) These values depend on the hardware 2 reference and the KGs selected.
And without water (except in the programme) The machine stops with the door lock activated All options are reset if: 1 Power is lost (unplug or ON/OFF).- Selector position changed.- If, when the programme finishes, the start button is pressed door open (F04).
A) Spin selection and anti-crease (flot) button The selected programme has an associated spin speed in revolutions per minute, as shown on the screen.
This fine is not considered a fault as it warns the user about the security studio measure the circuit has detected.
Range: Fagor Innovation Date: Document No: 9688 2 How to use this manual This document is intended for crack all persons rendering technical support services (T.S.S.).
Voltage: 220 v / 50 Hz Stator full resistance:.3 Rotor resistance:.7 Tachogenerator resistance: 184 Tachogenerator voltage:.2 v / 1,000 rpm Voltage: 220 v / 50 Hz Stator resistance:.3 Rotor resistance:.46 Tachogenerator resistance: 90 Voltage: 220 v / 50 Hz 16 Amp.Circuit validation (see table 1) Once the circuit has been configured louisiana it is 6 confirmed by pressing the start/pause button for 3 sec.« Anterior 1 2, seguinte deseja guardar a sua pesquisa?If this basic safety rule is not respected, the manufacturer shall under no circumstances accept liability for injuries suffered by persons or for damage to objects.3 Water inlet via the electronic valve for washing until wash level is reached 4 The resistance pipe starts to heat up until it reaches 40C Intermittent recirculation 90 sec.In the fi rst 6 attempts, the maximum unbalanced limit allowed is 550g.Nut-pulley drum support Pulley tool (AS ) 11 15 V3 and V4 circuit configuration If the circuit is not confi gured it will go into status as soon as it is plugged in (go crack to step.
(Can be checked in fagor aquatronic compact plus manual the BMF by its meaning TramaDatosATratar0 ) for more than 10 seconds, the fault F12 will be displayed.
Such risks may cause permanent damage to the product!
Breach of this copyright will be pursued in conformity with applicable legislation and may lead to criminal charges.