Peat step #4 to enter each additional ight plan instruction waypoint, ending at the nal destination airport.
3) Turn the large right knob to highlight the Map facility name (second line) or the city (third Range line) field.The fault detection part detects the presence of an unacceptably large pseudorange error (and presumably, position error) for a given mode of fl ight.2) A welcome page appears briefly while the unit performs a self test, followed sequentially.3) Turn the large right knob to highlight the data manual field to be instruction changed.An FDE prediction must be performed prior to departure for a fl ight plan involving: instruction Oceanic/Remote operation where GPS is to be the sole source of navigation per FAA Notice 8110.60.Within.0 nm of the final manual approach manual fix, flying the approach: instruction GPS-based appro. Click on the unit's ENT button once the identier for the desired waypoint is displayed.
Notam indicates a GPS repair satellite (or satellites) is scheduled to guia be out-of-service, per FAA AC 90-100.S.
The down arrow to zoom in to a smaller area.
To activate a saved ight guia plan:.With usuario the 400/500 Series durango Trainer running and the simulated 400/500 Series unit on, click on the units repair FPL button to display the ight pathfinder plan pages.
Approach, directly to the initial appro.Continue turning the From any page, press and hold the CLR Key for small right knob to select the desired data approximately two seconds.Adds the procedure to the flight plan without immediately using it for navigation guidance.2) Press the small right knob to display a panning pointer.To use the FDE Prediction Program, begin by entering the intended ight plan into the 400/500 Series Trainer software.
The FDE function is built into garmin 500 instruction manual the 400/500 Series unit and does not require pilot interaction.
Keep in mind the following while.0.
2) Press the small right knob to activate the 2) Press the small right knob to activate the cursor.